Share via

Dynamics 365 Pop Up Message that will not stop

Erika Winstead 0 Reputation points
2026-04-09T12:56:32.49+00:00

On Dynamics 365 on sales order page...When I go to analysis mode, I get a pop up that says, "We detected you are using columns that were previously added using a deprecated functionality. To add them back, use Add columns from functionality or ask Copilot to re-add them to the view." It comes up EVERY TIME, even when I switch views it will pop up again. I can select ok and make it go away, but I can't figure out how to make it stop. It's so annoying!

Microsoft 365 and Office | Development | Other
0 comments

2 answers

Sort by: Most helpful
Most helpful Newest Oldest
  1. Gabriel-N 15,600 Reputation points Microsoft External Staff Moderator
    2026-04-09T13:31:19.9166667+00:00

    Hello Erika Winstead

    Thank you for reaching out to the Microsoft Q&A Forum.

    Please note that Microsoft Dynamics 365 is currently not supported in the Q&A forums. We recommend posting your question in the official Microsoft Dynamics 365 Community, where subject matter experts can provide more accurate and in‑depth guidance: Find Answers | Microsoft Dynamics 365 Community

    The Dynamics 365 Community allows you to quickly find answers, join discussions, post questions, and connect with peers and product experts to troubleshoot issues related to Dynamics applications.

    In the meantime, based on the behavior you described, you may consider rebuilding the affected view without the deprecated columns to check whether the popup notification persists. However, please note that this is a general suggestion based on the available information and may not fully address the cause in all environments. For a more accurate investigation, it would be best to consult with Dynamics 365 specialists through the community mentioned above.

    Thank you for your understanding.

    Note: Please follow the steps in our documentation to enable e-mail notifications if you want to receive the related email notification for this thread.

    1 person found this answer helpful.
    0 comments
  2. Q&A Assist
    2026-04-09T12:56:50.8366667+00:00
    AI generated content. This question contains an answer created with AI from Q&A Assist. Learn more

    The behavior described is not covered in the provided context, and there is no documented way in the context to suppress or change that specific Dynamics 365 Sales analysis-mode popup.

    References:

    0 comments

Your answer

Answers can be marked as 'Accepted' by the question author and 'Recommended' by moderators, which helps users know the answer solved the author's problem.